3. Tighten the (M2x3) captive screw and replace the four (M2x3) screws to secure the system board to the chassis.
4. Route the power-button cable and the coin-cell battery cable through the routing guides.
5. Connect the power-button cable and the coin-cell battery cable to the connectors on the system board.
6. Route the WLAN antenna cables through the routing guides.
NOTE: The antennas should be aligned with the notches in the system board and the cable routing should not be over
the system board QR code.
Next steps
1. Install the solid-state drive.
2. Install the memory module.
3. Install the WLAN card.
4. Install the system fan.
5. Install the cover.
6. Install the hard-drive assembly.
7. Follow the procedure in after working on your device.
Heat-sink
Removing the heat-sink
Prerequisites
1. Follow the procedure in before working inside your device.
2. Remove the hard-drive assembly.
3. Remove the cover.
4. Remove the system fan.
5. Remove the WLAN card.
6. Remove the solid-state drive.
7. Remove the memory module.
8. Remove the system board.
About this task
The figure indicates the location of the heat-sink assembly and provides a visual representation of the removal procedure.
Removing and installing components
41
To Next Page
Loading...
