Dell EMC DP4400 - Remove and replace power supply

Install the IDPA pre-installation patch on the DataProtection-ACM
Before you begin
Before you configure the DataProtection-ACM virtual machine, install the latest IDPA pre-
installation patch if it is available.
For example:
Idpa_pre_update_N.N.N.nnnnnn.tar.gz
Where:
l
N.N.N is the latest pre-installation patch version.
l
nnnnnn is the build number.
You can install the pre-installation patch when the DataProtection-ACM is not registered with SRS
gateway by using SSH.
Procedure
1. Check https://support.emc.com/downloads/41849_Integrated-Data-Protection-Appliance
to see if a pre-installation patch is available for your version of IDPA. If a pre-installation
patch is available, download it to a folder on your laptop.
For example:
Idpa_pre_update_N.N.N.nnnnnn.tar.gz
Where:
l
N.N.N is the latest pre-installation patch version.
l
nnnnnn is the build number.
2. Open the WinSCP or SCP application on the service laptop, and then connect to the
DataProtection-ACM by performing the following actions:
a. In the File protocol field, select SFTP.
b. In the Hostname field, enter 192.168.100.100 as the IP address of the DataProtection-
ACM.
c. In the Port number field, specify the default port number 22.
d. In the User name field, enter root.
e. In the Password field, enter Idpa_1234.
f. Click Login.
The following figure shows a sample WinSCP session configuration window.
Dell EMC Integrated Data Protection Appliance DP4400 2.3 Installation Guide
13