Installation overview
This guide is designed for personnel who install, configure, and maintain the Integrated Data
Protection Appliance DP4400. To use this hardware publication, you should be familiar with digital
storage equipment and cabling.
Before you begin
Gather the required materials and configure your network environment as specified in Prepare the
site and unpack the system on page 3.
About this task
Use the following sequence of actions as a guide to install the system.
Procedure
1. Install and secure the rails.
2. Install the system in the cabinet and attach the bezel.
3. Connect the system to the network.
4. Connect the power cables and power on.
Results
The system is ready for initial configuration. To continue setup, refer to the
Integrated Data
Protection Appliance DP4400 Getting Started Guide
. For additional help and resources, review the
information in Additional resources on page 17.
Installation Guide
2 Dell EMC Integrated Data Protection Appliance DP4400 2.3 Installation Guide
To Next Page
Loading...
