Figure 7 Installing the front bezel
Connect the system to the network
The following figure shows the location of the DP4400 network ports and iDRAC port.
About this task
Figure 8
DP4400 network and iDRAC connections
Procedure
1. Use a Cat5e or Cat6 UTP copper Ethernet cable to connect a 1 GbE port (10) to the service
computer.
2. If the DP4400 contains 10Gb BASE-T network cards, use Cat6a UTP or Cat7 copper cables
to connect to the network switch.
3. If the DP4400 contains 10GB SFP network cards, use fiber cables with a 10 Gb optical SFP,
1GBaseT RJ-45 SFP with Cat5e or Cat6 UTP copper Ethernet cables, or direct-attached
copper cables to connect the four required 10 GbE ports (2, 3, 8, 9) to access ports on the
switch in your network.
Hardware Installation Guide
10 Dell EMC Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
To Next Page
Loading...
