Procedure
1. Align the screws with the designated U spaces on the front and rear rack flanges.
Ensure that the screw holes on the tab of the system retention bracket are seated on the
designated U spaces.
2. Insert and tighten the two screws using the Phillips #2 screwdriver.
Figure 3 Installing screws
Install the system in the cabinet
About this task
WARNING
The system is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the system in a
cabinet without a mechanical lift and/or help from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Dell EMC Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
7
To Next Page
Loading...
