• Auto Replace Member on Predictive Failure — allows you to enable or disable the option to start a Replace Member operation if a
predictive failure error is detected on a physical disk.
4 Select the applicable option and click Apply Changes.
The changes made are saved successfully.
Setting task rates
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Properties.
3 Click Task Rates.
The following options are displayed:
• Background Initialization (BGI) Rate
• Consistency Check Rate
• Rebuild Rate
• Reconstruction Rate
4 You can make the necessary changes and then click Apply Changes.
The task rates operation is completely successfully.
Enabling auto import
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Properties.
3 In the Controller Properties section, set the Auto Import Foreign Conguration option to Enabled.
4 Click Apply Changes.
The auto import is enabled successfully.
Disabling auto import
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Properties.
3 In the Controller Properties section, set the Auto Import Foreign Conguration option to Disabled.
4 Click Apply Changes.
The auto import is disabled successfully.
Selecting the boot mode
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Properties.
3 In the CONTROLLER PROPERTIES section, select the boot mode from the Boot Mode drop-down box.
The following list of boot mode options are displayed:
• Stop on errors
• Pause on errors
• Ignore errors
• Safe mode on errors
NOTE
: Note: By default, the boot mode option is set to Pause on errors.
4 Click Apply Changes.
HII
conguration utility 51
To Next Page
Loading...
