Dell EMC H745P MX - PERC H840 Enclosure Support

PERC H840 enclosure support
The H840 card is an external card. The H840 card supports:
• up to eight enclosures using single path conguration.
• up to four enclosure using multipath conguration.
To set up a conguration with redundant paths, both ports on a controller must be cabled to the ports of a single enclosure.
NOTE: The PERC H840 card supports redundant paths when used with Dell PowerVault MD14XX series disk storage
enclosures.
NOTE: The Enhanced HBA mode is not supported on PERC H840.
Figure 6. PERC H840 card ports — Four enclosures with multipath conguration
To set up an enclosure on the PERC H840 card:
a To connect multiple enclosures, two cables connect the rst enclosure to the second enclosure, then two more cables connect
the second enclosure to the third enclosure.
b To connect a single enclosure, cable the ports so that the enclosure is connected to both the ports on the controller card.
Features
17