Firmware
This section provides information about downloading and installing the rmware using Dell Update Package (DUP).
Installing the rmware using DUP
1 Navigate to Dell.com/support.
2 Locate your controller.
3 Download the DUP.
a For Window/iDRAC update, download Windows executable le.
b For Linux update, download .bin le.
NOTE: For VMware, rmware should be updated through iDRAC or the PERC CLI
utlitily.
4 Install the DUP.
a For Windows, run the executable in Windows environment.
b For Linux, run .bin le in Linux environment.
c For iDRAC, navigate to system iDRAC > Maintenance > System Update, upload Windows executable, and then install.
NOTE
: Firmware downgrade from 50.3.0-1022 (or later) to the older version is not supported via DUP.
NOTE: Firmware downgrade from 50.5.0-1750 to earlier versions is not supported while the controller is in eHBA
mode.
6
42 Firmware
To Next Page
Loading...
