Dell EMC H745P MX - Saving Controller Events; Saving Debug Log; Managing Link Speed; Restoring Factory Default Settings

Saving controller events
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Management.
3 Click Save Controller Events.
A screen is displayed indicating that the operation is completed successfully.
4 Click Ok.
Saving debug log
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Management.
3 Click Save Debug Log.
A screen is displayed indicating that the operation is completed successfully.
4 Click Ok.
Managing link speed
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Controller Management > Advanced Controller Management.
3 Click Manage Link Speed.
You can view/change the physical disk settings for the controller, if required. The possible options are:
• Auto
• 3 Gbps
• 6 Gbps
• 12 Gbps
4 Click Ok to save the changes.
NOTE
: To reect the changes, perform an AC power cycle that is disconnecting and reconnecting the power
source.
Restoring factory default settings
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Set Factory Defaults.
A screen is displayed asking you to conrm the operation.
3 Select Conrm and click Yes to continue.
48
HII conguration utility