Dell EMC H745P MX - Physical Disk Management

NOTE: Consistency check cannot be run on RAID 0 virtual disks.
4 From the Operations drop-down menu, select Check Consistency.
5 Click Go.
A screen is displayed asking if you are sure you want to perform the operation.
6 Select the Conrm option.
7 Click Yes.
The consistency check operation is completed successfully.
Physical disk management
Viewing physical disk properties
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Physical Disk Management.
All the physical disks associated with the RAID controller are displayed.
3 To view the properties, click on the physical disk. The following properties can be viewed on the physical disk:
Table 11. Physical disk properties
Option Description
Operation List of operations you can perform on the selected physical disk. The
options are:
• Blink
• Unblink
• Force Oine
• Replace Member
• Erase Options
• Global and Dedicated hotspare
• Convert to RAID Capable
• Convert to Non-RAID Disk
Device ID Unique identier of the physical disk.
Connection Number of paths and how wide the paths are to the physical disk.
Indicated if a physical disk is in a multipath conguration for H745P MX
and H840.
Backplane ID Backplane ID in which the physical disk is located in for H740P, H740 mini,
and H745P MX.
Enclosure Position The enclosure in which the physical disk is located for H840.
Chassis Slot Value The chassis slot value of the chassis slot in which the physical disk is
located when the physical disk is in a MX 5016s storage sled for the
controller H745P MX.
Slot Number The drive bay in which the physical disk is located for the corresponding
backplane or enclosure to which the controller is connected.
Status Status of the physical disk.
Size Size of the physical disk.
56 HII conguration utility