Dell EMC H745P MX - Cryptographic Erase; Physical Disk Erase; Assigning Global Hot Spare

Cryptographic erase
NOTE: The Cryptographic erase feature is supported only on ISE and SED drives.
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Physical Disk Management.
The list of physical disks is displayed.
3 Select a physical disk.
4 From the Operations drop-down menu, select Cryptographic Erase.
NOTE: If the drive installed is ISE or SED capable, then only the Cryptographic erase option is displayed.
5 Click Go.
A screen is displayed asking if you are sure you want to perform the operation.
6 Select the Conrm option.
7 Click Yes.
The Cryptographic erase operation is completed successfully.
Physical disk erase
To use the Physical Disk Erase feature from the HII Conguration Utility, perform the following steps:
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Physical Disk Management.
The list of physical disks is displayed.
3 Select a physical disk.
4 From the Operations drop-down menu, select Physical Disk Erase.
NOTE
: If the drive installed is neither SED or ISE capable, then only the Physical Disk Erase option is displayed.
5 Click Go.
A screen is displayed asking if you are sure you want to perform the operation.
6 Select the Conrm option.
7 Click Yes.
The physical disk erase operation is completed successfully.
Assigning global hot spare
To assign a global hot spare from the HII Conguration Utility, perform the following steps:
1 Enter the Dell PERC 10 Conguration Utility. See Navigating to Dell PERC 10 conguration utility.
2 Click Main Menu > Physical Disk Management.
The list of physical disks is displayed.
3 Select the physical disk.
4 From the Operations drop-down menu, select Assign Global Hot Spare.
5 Click Go.
A screen is displayed asking if you are sure you want to perform the operation.
6 Select the Conrm option.
58
HII conguration utility