Unable to register SCSI device error message
Error:
smartd[smartd[2338] Device: /dev/sda, Bad IEC (SMART) mode page, err=-5, skip
device smartd[2338] Unable to register SCSI device /dev/sda at line 1 of
file /etc/smartd.conf.
Corrective Action: This is a known issue. An unsupported command is entered through the user application. User applications attempt
to direct Command Descriptor Blocks to RAID volumes. The error message does not aect the feature
functionality. The Mode Sense/Select command is supported by rmware on the controller. However, the Linux
kernel daemon issues the command to the virtual disk instead of to the driver IOCTL node. This action is not
supported.
Disk carrier LED indicators
Each hard drive carrier has an activity indicator and a status indicator. The indicators provide information about the current status of the
hard drive. The activity LED indicates whether hard drive is currently in use or not. The status LED indicates the power condition of the
hard drive.
Figure 12. Hard drive indicators
1
activity LED 2 status LED
3 hard drive
NOTE: If the hard drive is in the Advanced Host Controller Interface (AHCI) mode, the status indicator (on the right side) does
not turn on.
Table 13. Hard drive indicator codes
Drive status indicator pattern Condition
Flashes green twice per second Identifying drive or preparing for removal.
O Drive ready for insertion or removal.
Flashes green, amber, and then turns o Predicted drive failure.
Troubleshooting 73
To Next Page
Loading...
