Configuration worksheet
Use this worksheet to collect and record information to start setting up your appliance
using the following:
l
Online Support
l
Appliance Configuration Manager (ACM)
l
Network Configuration wizard
Online Support
Record the following information related to your Online Support account:
Online Support credentials
To create an Online Support account, go to https://www.dell.com/support. Your
username and password is required for Secure Remote Services (formerly ESRS)
configuration.
Site ID
A Site ID is created in Support systems for each location within your organization
where Dell EMC products are installed. Your Site ID is required during initial
configuration. Verify your Site ID number on Online Support:
1. Log in to Online Support with your credentials.
2. Hover over your username and select Manage Company Information.
3. Click View Sites.
You can also search for a site and add it to the My Sites list. If a site ID is not available
or the correct site ID is not listed, you must notify your local field representative to
request one.
Connect to the ACM
Connect to the ACM user interface and begin the configuration process. For a
seamless experience, enable both private and public network connections to your
service computer.
Before you begin
l
After powering on the appliance, wait 5 minutes for startup to complete.
l
Verify that the service computer is connected to the 1 GbE port identified as (10)
in Figure 1 on page 15.
l
On the service computer, record the IP address settings for the Ethernet interface
that is connected to the DP4400.
IDPA uses the 192.168.100.xxx IP addresses for the internal components. Ensure
that the 192.168.100 network is not used in your environment. If the network
addresses are in use, contact Customer Support for assistance.
Setting up the IDPA Appliance
14 Dell EMC Integrated Data Protection Appliance 2.4 Getting Started Guide
To Next Page
Loading...
