Dell EMC IDPA DP4400 - Network Configuration Wizard

Results
The Network Configuration screen appears.
DP4400 ports
The following table provides the callout number and the type of port for the DP4400
ports in
Figure 1 DP4400 network and iDRAC connections
.
Table 4 DP4400 port types
Callout number Port type
1 iDRAC
2 10 GbE (required)
3 10 GbE (required)
4 10 GbE (unused)
5 10 GbE (unused)
6 10 GbE (unused)
7 10 GbE (unused)
8 10 GbE (required)
9 10 GbE (required)
10 1 GbE
11 1 GbE (unused)
Note
Ports 2 and 9 are a vSwitch0 network team. Ports 3 and 8 are a vSwitch1 network
team and are used during appliance configuration.
Note
Ensure that the four required 10 GbE ports (2, 3, 8, and 9) are connected to the
access ports on the switch in your network.
Network Configuration wizard
After accepting the EULA, configure initial connectivity to the DP4400 appliance.
The information that is required for this section is recorded in the
Integrated Data
Protection Appliance Pre-Engagement Questionnaire .
Note
The IDPA is compatible with IPv4 enabled networks and does not support pure IPv6 or
dual stack networks.
Procedure
1. Provide the following information to configure the basic network settings:
Setting up the IDPA Appliance
16 Dell EMC Integrated Data Protection Appliance 2.4 Getting Started Guide