It is recommended that you specify an IP range. IP ranges are not required, but they
do reduce the number of IP addresses that have to be typed manually during later
wizard steps.
Do not select the Select IP address range (11) check box if you are specifying non-
sequential IP addresses for each component in the configuration.
Customer information
Enter your customer contact information, including the name, email address, and
contact number of the administrator, and also the location name, company name, and
Site ID. Customer Support will use this information to contact you when needed.
Manual configuration of component IP addresses
If you selected IP address range on the General settings screen, go to Summary on
page 19.
If you did not select IP address range on the General settings screen, type an IP
address in each field on the following screens:
l
vCenter
l
Protection Storage
l
Backup Server
l
IDPA System Manager
l
Reporting and Analytics
l
Search
l
Cloud Disaster Recovery (if selected on the Welcome screen)
Summary
Review the configuration summary. To make changes, return to the previous screens.
When the configuration is correct, click Submit. The process continues automatically.
The configuration process takes several hours to complete, and continues on its own if
you disconnect from the DP4400. If your session is interrupted during configuration,
verify that you are connected to the network and type the ACM IP address in your
browser as follows:
https://<configured ACM IP address>:8543
If prompted, log in with the ACM credentials to view the current state of the
configuration progress.
Download configuration information
When the configuration process is complete, you can download the configuration
information as a PDF or XML file.
When you are finished, click Finish.
Setting up the IDPA Appliance
Customer information 19
To Next Page
Loading...
