The Network Configuration page is displayed.
5. In the Network Configuration page, under Network Settings section enter
the IP addresses in the following field and click Submit.
Ensure that you read the prerequisites before you configure the network
settings.
l
Subnet Mask
l
Gateway
l
Primary DNS server
l
Secondary DNS server
l
Domain Name
l
Appliance Configuration Manager IP Address
l
ESXi IP Address
l
NTP server
After you enter the IP addresses, you must confirm the changes that you have
made. To confirm the changes, perform the following actions.
Network configuration is a one-time activity and once configured you cannot
modify the configuration. To modify the configuration, you must contact the
Customer Support team.
a. In the Network Configuration dialog box, click Yes to apply the settings.
The Network Configuration progress page is displayed.
b. Click No to discard the changes.
After the configuration is completed the system logs out, and you are
redirected to the newly configured ACM IP Address. You must log in to the
ACM UI using your username and password.
6. In the Dell EMC Secure Remote Services for Integrated Data Protection
Appliance page, perform the following actions.
a. Enter the SRS Gateway IP.
b. Enter the online support credentials in the Username and Password fields.
c. Click Configure.
The IDPA Appliance configuration page is displayed.
If you want you can skip the Secure Remote Services configuration and can
configure it from the ACM dashboard later.
7. In the IDPA Appliance configuration page, perform the following actions.
Setting up the IDPA Appliance
Install and deploy IDPA 21
To Next Page
Loading...
