Dell EMC IDPA DP4400 - Deploy an Avamar Proxy

Deploy an Avamar proxy
This section provides you information about how to deploy the Avamar proxy.
Deploy the Avamar proxy on each vCenter that you intend to protect.
Procedure
1. Open a browser and enter https://<ACM IP address>:8543 to access
the ACM UI.
2. Click IDPA System Manager Web UI and log in to the System Manager.
The IDPA System Manager dashboard page is displayed.
3. Click System Management on the left pane to display the System
Managerpage.
4. Click the vertical ellipsis for the Avamar-Backup Server and select Avamar
Proxy Deployment.
The Proxy Management page on the Avamar UI is displayed.
5. In the right pane, click the vertical ellipsis in front of the IDPA Backup Server
and select Avamar Proxy Deployment.
6. In the Config section, perform the following actions. Data Change Rate, and
Backup Window. Then select the checkbox.
a. Select the vCenter that you added. For more information about adding a
vCenter, see Define vCenter and VMware clients
b. Enter the data change rate in the Data Change Rate (%) field.
c. Enter the number of minutes in the Backup Window (minutes) field.
d. Select the Protect Virtual Machines on Local Storage checkbox.
7. Click CREATE RECOMMENDATION.
The Recommendations section displays the proposed new proxies under each
host.
8. Expand the listings in the Recommendations section and select New proxy
under the ESXi server host.
9.
Click
.
The Proxy window is displayed.
a. Enter the proxy hostname in the Name field.
b. Select an Avamar server Domain where this proxy resides.
c. Enter the IP address in the IP field.
d. Select a datastore from the Datastore list.
e. Select a network from the Network list.
f. Enter the server name or IP address in the DNS field.
g. Enter the network gateway IP address in the Gateway field.
h. Enter the network mask in the Netmask field.
i. Enter the IP address in the NTP field.
Performing a VM backup
Deploy an Avamar proxy 39