Dell EMC IDPA DP4400 - Remove Internal Hard Drives

Install the front bezel
The procedure to install the front bezel with the LCD panel and the front bezel
without the LCD panel is the same.
Procedure
1. Align and insert the right end of the bezel onto the system.
2. Press the release button and fit the left end of the bezel onto the system.
3. Lock the bezel by using the key.
Figure 10 Installing the front bezel
Remove internal hard drives
Extend the system from the cabinet
This procedure is used to extend the system from the cabinet so that the system
cover can be removed to access the internal FRU components, or used in removing
the system from the cabinet.
Note
When replacing hot-swappable components, ensure the system cables are long
enough to stay connected while the unit is extended.
Procedure
1. At the front of the cabinet, locate the two rocker switches on left and right side
of the system. Press the top of the rocker switches inward to release the
system from the cabinet.
Remove and replace assemblies
24 Dell EMC IDPA DP4400 Service Procedures