If the rocker switches do not disengage the system, loosen the screw under
each rocker.
2. Pull the system from the cabinet until the rails lock in the extended position.
Figure 11 Release and extend system from cabinet
Remove the system cover
Procedure
1. Using a flat or a Phillips head screwdriver, rotate the latch release lock counter
clockwise to the unlocked position.
2. Lift the latch till the system cover slides back and the tabs on the system cover
disengage from the guide slots on the system.
3. Hold the cover on both sides, and lift the cover away from the system.
Figure 12
Removing the system cover
Remove and replace assemblies
Remove the system cover 25
To Next Page
Loading...
