Dell EMC IDPA DP4400 - Remove Hard Drive Carrier from the MID Hard Drive Tray; Replace a Hard Drive in the MID Hard Drive Tray

Remove hard drive carrier from the mid hard drive tray
Before you begin
CAUTION
When a replacement hot swappable hard drive is installed and the system is
powered on, the hard drive automatically begins to rebuild. Ensure that the
replacement hard drive is blank or contains data that you wish to overwrite. Any
data on the replacement hard drive is immediately lost after the hard drive is
installed.
CAUTION
Mixing hard drive carriers from previous generations of PowerEdge servers is not
supported.
Procedure
1. Lift the hard drive carrier handle upward.
2. Press the release tab on the hard drive tray and lift the hard drive carrier handle
upward to disengage the hard drive from the backplane.
3. Hold the hard drive carrier handle and lift the hard drive carrier out of the hard
drive tray.
Figure 13
Removing hard drive carrier from the mid hard drive tray
Replace a hard drive in the mid hard drive tray
Before you begin
Procedure
1. Remove the hard drive carrier from the mid hard drive tray
Note
To replace a hard drive that is mounted in the mid hard drive tray, perform the
following steps as applicable to the type of hard drive that is installed:
Remove and replace assemblies
26 Dell EMC IDPA DP4400 Service Procedures