Slide the system into the cabinet
Procedure
1. At the front of the cabinet, push the system inward until the lock levers click
into place.
2. Push the blue slide release lock tabs forward on both rails and slide the system
into the cabinet. The slam latches will engage to secure the system in the
cabinet.
Figure 17 Slide the system into the cabinet
Verifying successful disk replacement from the ACM
After a disk is replaced, you can run the FRU command line verification from the ACM
to ensure that the replacement was successful.
Procedure
1. From the ACM, type the following command: # showfru disk
The screen displays that the system is collecting data. When the data collection
is completed, the screen displays status information for the disks.
acme-dp4400-ACM:~ # showfru disk
Collecting Data............
________________________________________________________________________________________
__
| ID| State | Status| Model# | Serial# | FW Version| Capacity| Operation|
OpStatus|
|
========================================================================================
=|
| 0 | Online| OK | HUH721212AL5200| 8DGPKT5H| NS01 | 10.69TB | None |
0% |
| 1 | Online| OK | HUH721212AL5200| 8DGPAZZH| NS01 | 10.69TB | None |
Remove and replace assemblies
30 Dell EMC IDPA DP4400 Service Procedures
To Next Page
Loading...
