Dell EMC IDPA DP4400 - Remove MID Hard Drive Tray

Figure 26 Remove the system cover
Remove mid hard drive tray
Follow the following procedure to remove the middle hard drive tray.
Before you begin
CAUTION
The hard drive tray is hot to touch for some time after the system has been
powered down. Allow time for the hard drive tray to cool before handling it.
Procedure
1. Disconnect all the cables from the hard drive backplane.
2. Lift the hard drive tray handles 90 degrees upward.
3. Hold the hard drive tray handles, and lift the hard drive tray out of the system.
Remove and replace assemblies
42 Dell EMC IDPA DP4400 Service Procedures