Figure 27 Removing mid hard drive tray
Remove the memory module
The procedure for removing a memory module and NVDIMM-N is identical.
Before you begin
Allow the memory modules to cool after you power off the system. Handle the
memory modules by the card edges and avoid touching the components or
metallic contacts on the memory module.
To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you
intend to install memory modules in those sockets.
You must follow the thermal restriction while using DIMM blanks.
Procedure
1. Locate the appropriate memory module socket.
Handle each memory module only by the card edges, ensuring not to touch
the middle of the memory module or metallic contacts.
2. Push the ejectors outward on both ends of the memory module socket to
release the memory module from the socket.
3. Lift and remove the memory module from the system.
Remove and replace assemblies
Remove the memory module 43
To Next Page
Loading...
