Dell EMC IDPA DP4400 - Install the Memory Module

Figure 28 Removing a memory module
Install the memory module
The procedure for installing a memory module and NVDIMM-N is identical.
Before you begin
Follow all safety guidelines. Ensure that you where an ESD wrist strap when handling
DIMMs and other internal components.
CAUTION
Ensure that you install the NVDIMM-N battery if you are using NVDIMM-N.
CAUTION
To prevent data loss and potential damage to your system, ensure that your
system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery
are turned off before installing the NVDIMM-N battery.
CAUTION
To ensure proper system cooling, memory module blanks must be installed in any
memory socket that is not occupied. Remove memory module blanks only if you
intend to install memory modules in those sockets.
Note
You must follow the thermal restriction while using DIMM blank. For information about
thermal restriction, see the Thermal restrictions section.
Procedure
1. Locate the appropriate memory module socket.
CAUTION
Handle each memory module only by the card edges, ensuring not to touch
the middle of the memory module or metallic contacts.
Remove and replace assemblies
44 Dell EMC IDPA DP4400 Service Procedures