5. Connect all the cables to the hard drive backplane.
Figure 30 Installing the mid hard drive tray
Install the system cover
Procedure
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the
guide slots on the system and the system cover latch locks into place.
3. Using a flat or Phillips head screwdriver, rotate the latch release lock clockwise
to the locked position.
Remove and replace assemblies
46 Dell EMC IDPA DP4400 Service Procedures
To Next Page
Loading...
