Dell EMC IDPA DP4400 - Page 52

Figure 35 Removing the BOSS card from expansion card riser 1
Remove M.2 module from the BOSS Card
Procedure
1. Identify the M.2 module to be replaced.
The bottom M.2 module is in Slot 0, and the top M.2 module is in Slot 1.
2. Unscrew the screw that secures the M.2 module on the BOSS card.
3. Lift the M.2 module away from the BOSS card.
Figure 36
Removing the M.2 module
1. module connector (2)
2. screws (2)
Remove and replace assemblies
52 Dell EMC IDPA DP4400 Service Procedures