3. modules (2)
Install M.2 module on the BOSS Card
Procedure
1. Align the M.2 module connectors with the connectors on the BOSS card.
2. Tilt the M.2 module downwards until the module is seated firmly on the card.
3. Tighten the screw that secures the M.2 module on the BOSS card.
Figure 37 Installing the M.2 module
1. module connector (2)
2. screws (2)
3. modules (2)
Install BOSS card onto expansion card riser 1
Procedure
1. Pull the expansion card latch out of the slot.
2. Hold the BOSS card by its edges, and align the card edge connector with the
expansion card connector on the riser.
3. Insert the BOSS card edge connector firmly into the expansion card connector
until the card is fully seated.
4. Push the expansion card latch into the slot.
Remove and replace assemblies
Replace an M.2 module 53
To Next Page
Loading...
