Figure 44 Removing the 3.5 inch hard drive rear cage
Remove the network daughter card
Procedure
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the
network daughter card (NDC) to the system board.
2. Hold the NDC by the edges on either side of the touch points, and lift to remove
it from the connector on the system board.
3. Slide the NDC towards the front of the system until the Ethernet connectors
are clear of the slot in the back panel.
Figure 45
Removing the network daughter card
Remove and replace assemblies
Remove the network daughter card 61
To Next Page
Loading...
