Dell EMC IDPA DP4400 - Install the Network Daughter Card; Install the Rear Hard Drive Cage

Install the network daughter card
Procedure
1. Orient the NDC so that the Ethernet connectors fit through the slot in the
chassis.
2. Align the captive screws at the back-end of the card with the screw holes on
the system board.
3. Press the touch points on the card until the card connector is firmly seated on
the system board connector.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC
to the system board.
Figure 46 Installing the network daughter card
Install the rear hard drive cage
Procedure
1. Align the screws on the hard drive cage with the screw holes on the system.
2. Lower the hard drive cage into the system until it is firmly seated.
3. Using Phillips #2 screwdriver, tighten the screws to secure the hard drive cage
to the system.
4. Connect all the cables to the rear hard drive backplane.
Remove and replace assemblies
62 Dell EMC IDPA DP4400 Service Procedures