Figure 47 Installing the 3.5 inch rear hard drive cage
Install the network interface card into expansion card riser 1
Before you begin
Follow all safety guidelines.
Procedure
1. Unpack the network interface card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Pull the expansion card latch.
3. If installed, remove the filler bracket.
Store the filler bracket for future use. Filler brackets must be installed in empty
expansion card slots to maintain Federal Communications Commission (FCC)
certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
4. Hold the network interface card by its edges, and align the card edge connector
with the expansion card connector on the riser.
5. Insert the card edge connector firmly into the expansion card connector until
the card is fully seated.
6. Push the expansion card latch into the slot.
Remove and replace assemblies
Install the network interface card into expansion card riser 1 63
To Next Page
Loading...
