Replacing the fan
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align the screw holes on the fan with the screw holes on to the palm-rest and keyboard board assembly.
2. Route the display cable through the routing guides on the fan.
3. Replace the two screws (M2.5x5) that secure the fan to the palm-rest and keyboard board assembly.
4. Connect the fan cable to the system board.
24
Removing and installing components
To Next Page
Loading...
