working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Adhere the power-adapter port cable to the palm-rest and keyboard assembly.
3. Replace the screw (M2x2) that secures the power-adapter port to the palm-rest and keyboard assembly.
Post-requisites
1. Replace the system board.
2. Replace the display assembly.
3. Replace the wireless card.
4. Replace the memory modules.
5. Replace the battery.
6. Replace the base cover.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the base cover.
Removing and installing components
57
To Next Page
Loading...
