Installing the power-button board
About this task
The following images indicate the location of the power-button board and provide a visual representation of the installation
procedure.
Steps
1. Align and place the power-button board on the palm-rest assembly.
2. Replace the two screws (M2x2.5) that secure the power-button board to the palm-rest assembly.
Next steps
1. Install the system board.
2. Install the assembly inner frame.
3. Install the battery.
4. Install the solid-state drive.
5. Install the memory module.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the base cover.
9. Install the microSD card.
10. Install the SIM card.
11. Follow the procedure in After working inside your computer.
52
Removing and installing components
To Next Page
Loading...
