Steps
1. Align and place the keyboard assembly on the palm-rest assembly.
2. Replace the 17 screws (M2x2) that secure the keyboard assembly to the palm-rest assembly.
3. Connect the keyboard cable to the connector on the touch-pad.
Next steps
1. Install the system board.
2. Install the assembly inner frame.
3. Install the battery.
4. Install the solid-state drive.
5. Install the memory module.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the base cover.
9. Install the microSD card.
10. Install the SIM card.
11. Follow the procedure in After working inside your computer.
Keyboard bracket
Removing the keyboard bracket
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing components
57
To Next Page
Loading...
