Message
number
Message Suggested action
1105 Failed to run command “{cmd}” on storage system at {system}:
{err}
Verify the IP address conguration on the storage
system and on the host, and check network connectivity.
2001 Volume {volume}({name}) is already unmapped. SRM requested that a volume be prepared for failover,
but the volume is already prepared.
2002 No data found for {volume}replication image {imageSn} ({err}). Verify that replication has started for volume {volume}.
2003 querySyncStatus: No data found for replication image {imageSn}
for volume {vol} ({err}).
Verify that replication has started for the specied
volume.
NOTE: You can expect to see certain errors in the log le when commands are executed to ensure that volumes are in a
particular state if the volumes are already in that state. These errors are -3395 (Replication is not active on this
secondary volume) and -10306 (Unable to set the specified volume as the primary volume because
the specified volume is already a primary volume). You can safely disregard these error messages if they occur
under these circumstances.
Troubleshooting 13
To Next Page
Loading...
