Dell EMC ME4 Series - Mini-USB Device Connection

Table 29. Terminal emulator display settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Font Terminal
Translations None
Columns 80
Table 30. Terminal emulator connection settings
Parameter Value
Connector COM3 (for example)
1,2
Baud rate 115,200
Data bits 8
Parity None
Parmaeter Value
Stop bits 1
Flow control None
1
Your server or laptop conguration determines which COM port is used for Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
3 In the terminal emulator, connect to controller A.
4 Press Enter to display the CLI prompt (#).
The CLI displays the system version, Management Controller version, and login prompt
a At the login prompt, enter the default user manage.
b Enter the default password !manage
If the default user or password—or both—have been changed for security reasons, enter the secure login credentials instead of the
defaults shown above.
Mini-USB Device Connection
Emulated serial port
Once attached to the controller module, the management computer should detect a new USB device. Using the Emulated Serial Port
interface, the ME4 Series controller presents a single serial port using a customer vendor ID and product ID. Eective presentation of the
emulated serial port assumes the management computer previously had terminal emulator installed. See also Supported host applications.
Serial port conguration is unnecessary.
IMPORTANT
: Certain operating systems require a device driver or special mode of operation to enable proper functioning of the
USB CLI port. See also Device Driver special operations mode.
142 Connecting through the CLI port using a serial cable