Figure 71. Installing the riser 2 blank
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Identifier GUID-786B1D5C-710F-4E59-943D-8CEE2364EFF8
Status Released
Removing the expansion card riser 1
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the expansion cards from the riser.
4 Disconnect any cables connected to the riser.
Step
Press the release latches, and lift the riser from the riser connector on the system board.
Installing and removing system components
123
To Next Page
Loading...
