Figure 77. Installing the network daughter card
Next steps
1 Install the expansion card riser 2 or the rear drive cage, depending on the conguration of your system.
2 Follow the procedure listed in After working inside your system.
Identifier GUID-C7BDCD8B-98CC-4A6C-B2D1-7A16C08C5F84
Status Released
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives and also enables you
to set up the drives in RAID congurations as supported by the version of the storage controller.
This section contains information about the removal and installation of the integrated storage controller card.
Identifier GUID-42EFA0E6-12AD-40A8-8558-59DA93C3F46F
Status Released
Removing the integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the expansion card riser 1.
Steps
1 Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2 Lift the integrated storage controller cable away from the integrated storage controller.
Installing and removing system components
129
To Next Page
Loading...
