Figure 86. Removing the backplane
NOTE: The images shown here are for representation only and the actual conguration of your system may vary.
Next step
Install the backplane.
Identifier GUID-660F0CFB-45A0-4F60-9CFB-6A03798BA130
Status Released
Installing the backplane
The procedure to install the backplane is identical for all backplane congurations.
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Use the hooks on the system as guides to align the drive backplane.
2 Lower the drive backplane until the release tabs snap into place. If applicable, tighten the captive screws on the backplane.
Installing and removing system components
135
To Next Page
Loading...
