Dell EMC NX3240 - Initializing TPM for Bitlocker Users

CAUTION: Once the TPM plug-in module is installed, it is cryptographically bound to that specic system board. Any attempt to
remove an installed TPM plug-in module breaks the cryptographic binding, the removed TPM cannot be reinstalled or installed on
another system board.
Identifier TASK_4FB15E7BD150441ABAC5FCABD025B9C7
Status
Removing the TPM
1 Locate the TPM connector on the system board.
2 Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3 Slide the TPM module out from its connector.
4 Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5 Pull the plastic rivet out of its slot on the system board.
Identifier TASK_70E2B5344C8C44638E209CBA77B30048
Status
Installing the TPM
Steps
1 To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2 Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3 Press the plastic rivet until the rivet snaps into place.
Figure 104. Installing the TPM
Next steps
1 Install the system board.
2 Follow the procedure listed in After working inside your system.
Identifier GUID-E5792F47-37D9-400B-A997-337D96E46665
Status Released
Initializing TPM for BitLocker users
Initialize the TPM.
Installing and removing system components
153