Dell EMC NX3240 - Removing the Left Control Panel

• Right control panel: Contains power button, USB 2.0 port, VGA port micro USB for iDRAC Direct, and status LED for iDRAC Direct.
This section contains information about the removal and installation of the left and right control panel.
Identifier GUID-5F659729-2B81-4766-A5CB-27C23460422B
Status Released
Removing the left control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the cooling fan assembly.
4 Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1 Pull the cable latch and disconnect the control panel cable from the system board connector.
2 Using Phillips #1 screwdriver, remove the screws to remove the cable cover, which secure the lest control panel and cable tube to the
system.
3 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
Figure 105. Removing the left control panel
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Next step
Install the left control panel.
Installing and removing system components
155