Identifier GUID-FE493934-019F-454F-8EAE-368A04136332
Status Released
Installing the left control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the left control panel assembly with the control panel slot on the system and attach the control panel assembly to the system.
3 Connect the control panel cable to the system board connector and secure it using cable latch.
4 Using Phillips #1 screwdriver, install the screws that secure the control panel and cable tube to the system.
Figure 106. Installing left control panel
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Next steps
1 Install the air shroud.
2 Install the cooling fan assembly.
3 Follow the procedure listed in After working inside your system.
156
Installing and removing system components
To Next Page
Loading...
