Identifier GUID-C80C812E-5016-4EF6-8579-99D7AE94DAF9
Status Released
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable and VGA cable through the side wall of the system.
2 Align the control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the VGA cable to the system board.
4 Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
5 Using Phillips #1 screwdriver, install the screw that secures the control panel and cable tube to the system.
Figure 108. Installing right control panel
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Next steps
1 Install the cooling fan assembly.
2 Install the air shroud.
3 Follow the procedure listed in After working inside your system.
158
Installing and removing system components
To Next Page
Loading...
