Dell EMC NX3240 - 4 Initial System Setup and Configuration; Setting up Your System; Idrac Configuration; Options to Set up Idrac IP Address

Identifier GUID-5748796D-6E9F-4449-ABF4-8D669F585840
Status Released
Initial system setup and conguration
Identifier GUID-5E4FB623-5A16-4E63-A539-4D2EC304F4E1
Status Released
Setting up your system
Complete the following steps to set up your system:
1 Unpack the system.
2 Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation
Placemat
at Dell.com/storagemanuals.
3 Connect the peripherals to the system.
4 Connect the system to its electrical outlet.
5 Turn the system on by pressing the power button or by using iDRAC.
6 Turn on the attached peripherals.
Identifier GUID-B7DABD59-D2F1-46E4-9022-6314E97E19D3
Status Released
iDRAC conguration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell EMC systems. iDRAC alerts administrators to system issues, helps them perform remote system management, and
reduces the need for physical access to the system.
Identifier GUID-96138E53-DA2D-4B3E-A7BE-B59FB9A16D8D
Status Released
Options to set up iDRAC IP address
You must congure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You
can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
utility
See Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
4
Initial system setup and conguration 35