Dell EMC NX3240 - Page 45

Option Description
Processor n
NOTE: Depending on the number of CPUs, there might be up to two processors listed.
The following settings are displayed for each processor installed in the system:
Option Description
Family-Model-
Stepping
Species the family, model, and stepping of the processor as dened by Intel.
Brand Species the brand name.
Level 2 Cache Species the total L2 cache.
Level 3 Cache Species the total L3 cache.
Number of Cores Species the number of cores per processor.
Identifier GUID-72553542-6D61-4223-8EF0-BDA6A102004C
Status Released
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable SATA and PCIe RAID mode on your system.
NOTE
: Dell EMC NAS system does not support HDDs connected to SATA ports and does not enable SATA RAID Mode. It
supports only PERC RAID Controller.
Identifier GUID-8DF144AD-3F7C-4199-9BA5-C237314C58C6
Status Released
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click SATA Settings.
Identifier GUID-C7891C34-B609-4EEE-9590-C55FD7058CA5
Status Released
SATA Settings details
The SATA Settings screen details are explained as follows:
Option
Description
Embedded SATA Enables the embedded SATA option to be set to O , AHCI, or RAID modes. This option is set to AHCI Mode by
default.
Pre-operating system management applications 45