Dell EMC NX3240 - Page 46

Option Description
Security Freeze
Lock
Sends Security Freeze Lock command to the embedded SATA drives during POST. This option is applicable only
for AHCI Mode. This option is set to Enabled by default.
Write Cache Enables or disables the command for the embedded SATA drives during POST. This option is set to Disabled by
default.
Port n Sets the drive type of the selected device.
For AHCI Mode or RAID Mode, BIOS support is always enabled.
Option Description
Model Species the drive model of the selected device.
Drive Type Species the type of drive attached to the SATA port.
Capacity Species the total capacity of the drive. This eld is undened for removable media
devices such as optical drives.
Identifier GUID-DD0872E4-FC1B-48F0-828A-458FD68AACF8
Status Released
Boot Settings
You can use the Boot Settings screen to set the boot mode to BIOS. It also enables you to specify the boot order.
BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.
Identifier GUID-9DFF93EA-B591-4250-ABA4-53DAFA980D0F
Status Released
Viewing Boot Settings
To view the Boot Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Boot Settings.
Identifier GUID-298F58F0-BE30-41D4-B419-AE3BCD17549B
Status Released
Boot Settings details
The Boot Settings screen details are explained as follows:
Option
Description
Boot Mode Enables you to set the boot mode of the system.
46 Pre-operating system management applications