Dell EMC NX3240 - Network Settings; Viewing Network Settings

Steps
1 On the System Setup Main Menu screen, click System BIOS > Boot Settings > UEFI/BIOS Boot Settings > UEFI/BIOS Boot
Sequence..
2
Click Boot Option Settings > BIOS > Boot Sequence.
3 Use the arrow keys to select a boot device, and use the plus (+) and minus (-) sign keys to move the device down or up in the order.
4 Click Exit, and then click Yes to save the settings on exit.
Identifier GUID-AF19B989-7A73-4D57-8085-83DA08B821C4
Status Released
Network Settings
You can use the Network Settings screen to modify iSCSI boot settings. The network settings option is available only in the UEFI mode.
NOTE: The Dell EMC Storage NX3240 system supports only BIOS mode. You must not change the boot mode to UEFI because
the system does not boot.
NOTE: The BIOS does not control network settings in the BIOS mode. For the BIOS boot mode, the option ROM of the network
controllers handles the network settings.
Identifier GUID-1A7D5294-D618-4BD3-82B5-302F3F549D00
Status Released
Viewing Network Settings
To view the Network Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Network Settings.
Identifier GUID-6A2D2BAD-44B4-48EA-9AD2-ACEFAC84E060
Status Released
Network Settings screen details
The Network Settings screen details are explained as follows:
NOTE
: The Dell EMC Storage NX3240 system does not support UEFI mode.
Option Description
PXE Device n (n = 1
to 4)
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the device.
PXE Device n
Settings(n = 1 to 4)
Enables you to control the conguration of the PXE device.
HTTP Device n (n =
1 to 4)
Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the device.
48 Pre-operating system management applications