Dell EMC NX3240 - Page 50

Option Description
iSCSI Device1 Enables or disables the iSCSI device. When disabled, a UEFI boot option is created for the iSCSI device
automatically.
iSCSI Device1
Settings
Enables you to control the conguration of the iSCSI device.
Identifier GUID-64A0F974-4BD2-4948-A7B6-1B8ABC8DA19C
Status Released
Integrated Devices
You can use the Integrated Devices screen to view and congure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Identifier GUID-B384C377-590A-497B-A775-C97EDE68AE33
Status Released
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Integrated Devices.
Identifier GUID-1EFF8FD4-A949-47ED-ACF2-292341FDBDEF
Status Released
Integrated Devices details
The Integrated Devices screen details are explained as follows:
NOTE
: The Dell EMC Storage NX3240 system does not support UEFI mode.
Option Description
User Accessible
USB Ports
Congures the user accessible USB ports. Selecting Only Back Ports On disables the front USB ports; selecting
All Ports O disables all front and back USB ports; selecting All Ports O (Dynamic)All Ports On disables all front
and back USB ports during POST and front ports can be enabled or disabled dynamically by authorized user
without resetting the system.
The USB keyboard and mouse still function in certain USB ports during the boot process, depending on the
selection. After the boot process is complete, the USB ports will be enabled or disabled as per the setting.
Internal USB Port Enables or disables the internal USB port. This option is set to On or O. This option is set to On by default.
iDRAC Direct USB
Port
The iDRAC Direct USB port is managed by iDRAC exclusively with no host visibility. This option is set to ON or
OFF. When set to OFF, iDRAC does not detect any USB devices installed in this managed port. This option is set
to On by default.
50 Pre-operating system management applications