Dell EMC NX3240 - System Cover; Removing the System Cover

Figure 15. Installing the front bezel with the LCD panel
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Identifier GUID-52869831-5B98-41AE-B6A3-C7045DB915D6
Status Released
System cover
System cover provides security for the entire system and also helps in maintaining proper air ow inside the system.
This section contains information about the removal and installation of the system cover.
Identifier GUID-5F7CAC65-CA63-4069-BF36-AFA4DCC05ABD
Status Released
Removing the system cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Turn o the system, including any attached peripherals.
3 Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1 Using a 1/4 inch at head or a Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked position.
2 Lift the latch till the system cover slides back and the tabs on the system cover disengage from the guide slots on the system.
3 Hold the cover on both sides, and lift the cover away from the system.
66
Installing and removing system components