Figure 17. Installing the system cover
NOTE
: The images shown here are for representation only and the actual conguration of your system may vary.
Next steps
1 Reconnect the peripherals and connect the system to the electrical outlet.
2 Turn on the system, including any attached peripherals.
Identifier GUID-85840C4F-E24E-4096-AC07-6EF292182837
Status Released
Backplane cover
This section contains information about the removal and installation of the backplane cover.
Identifier GUID-2698E0E8-EBD7-4D2D-A767-3C577F5DF143
Status Released
Removing the backplane cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
68
Installing and removing system components
To Next Page
Loading...
